Crosshead movement responds to manually pushing or pulling on the force gauge shaft or load cell. Increasing force produces greater speeds. Ideal for setups and quick positioning.

Included when ordering the ESM303-003 safety shield.

• Series 7 or 5 gauge or indicator with load cell
• 09-1214 interface cable

• If data output to a PC is required, add 09-1214 and 09-1158 cables, and a Series 7 or 5 gauge or indicator with load cell.
• Field activation requires hardware installation. Otherwise, hardware is factory installed at time of order.

The ESM303 may be fully controlled by a PC through a custom-written program in any language supporting ASCII communications. Also responds to the legacy Chatillon TCD command set and legacy Nexygen TCD software (not available from Mark-10).

This option is not required for MESUR™gauge Plus software.

• Series 7 or 5 gauge or indicator with load cell
• AF009 travel indication
• 09-1214 interface cable
• 09-1158 USB output cable
• For full speed range, consider AF017 and AF018 speed range extensions

• AF009 travel indication option

• Series 7 or 5 gauge or indicator with load cell
• 09-1214 interface cable

• If reversing at force set point: Series 7 or 5 gauge or indicator with load cell, and 09-1214 interface cable
• If reversing at travel limit: AF011 programmable travel limits option
• If reversing at break: AF019 break detection option and 09-1214 interface cable

• Same as auto return, at the same speed in each direction. Add AF016 for independent up and down speeds.

-

-

-

• Series 7 or 5 gauge or indicator with load cell
• 09-1214 interface cable

• Series 7 or 5 gauge or indicator with load cell
• If a specified time is required, add AF014 cycling / dwell time option
• 09-1214 interface cable

• AF009 travel indication
• Series 7 or 5 gauge or indicator with load cell
• 09-1214 interface cable